Yokogawa ADMAG AXF - Manual (Page 54)

IM 1E10C1-E
7-4
7. OPERATION VIA HART COMMUNICATOR
7.2.2 Display
The HART Communicator automatically searches for ADMAG SE on the 4 to 20 mA
loop when it is turned on. When the HART Communicator is connected to the ADMAG
SE, it displays “Online” menu as shown below.
(If ADMAG SE is not found, the communicator displays the message “No Device
Found. Press OK....” Press the OK ‘F4’ function key and the main menu appears. Please
retry after confirming the connection with the ADMAG SE.)
Manufacturer’s Field Device
Type Code Tag (8 Characters) <1>
<2>
<3>
<4>
<5>
Function keys
appears when the voltage
level of the battery is low
The arrow mark corresponding
to the pressed key appears.
Inverse video bar
Figure 7.2.2 Display
<1> appears and flashes during communication between the HART Communicator
and the ADMAG SE. At Burst mode*, appears.
<2> The current display menu title appears.
<3> Each item in menu of <2> appears.
<4> and/or appear when the items are scrolled out of the display.
<5> On any given menu, the label appearing above a function key indicates the function
of that key for the current menu.
Note: Refer to “7.3.4 Setting Parameters (7) Burst Mode”.
7.2.3 Calling Up Menu Addresses
7.3.3 Menu Tree shows the configuration of Online Menu which is needed for the
operation with HART Communicator. The desired item can be displayed with ease by
understanding the menu configuration.
When the HART Commnicator is connected to the ADMAG SE, “Online” menu will be
displayed after the power is turned on (See figure 7.2.2). Call up the desired item as
follows: