3 interface specifications, 3 interface specifications -10, Interface specifications – Proface APL3000B - Node Box PC User Manual
Page 51: 10 3.3 interface specifications, Serial interfaces
PL3000 Series Hardware Manual
3-10
3.3
Interface Specifications
This section describes the specifications of each interface of the PL Series unit.
Serial Interfaces
Serial Interfaces (COM1)
This interface is used to connect an RS-232C/RS-422/RS-485
*1
serial cable. A D-sub 9-pin plug connector is
used.
RS-232C
• This PL unit’s serial port is not isolated. Always connect the #5 SG (Signal
Ground) of the PL unit to the connected device, especially if the connected device
is also not isolated. Failure to do so may damage the RS232C/RS422/RS485
circuit.
• The SG (signal ground) and FG (frame ground) terminals are connected
internally in the PL unit. When connecting the SG line to another device, be sure
that the design of the system/connection does not produce a shorting loop.
• Connect FG terminal line to housing.
• Do not connect any pins to COM1 [NC].
*1
To change the communication method, set the DIP switch located on the circuit board in the PL
unit to the desired position. The factory setting is RS-232C. Please refer to “3.4 Internal Switch-
es Specifications” (page 3-16).
*2
To change the CI (RI)/+5V setting of pin #9, set the slide switch located on the circuit board in
the PL unit to the desired position. Please refer to “3.4 Internal Switches Specifications” (page
Interfit Bracket
#4-40 (UNC)
Pin Arrangement
Pin No.
RS-232C
Signal Name
Direction
Description
1
CD
Input
Carrier Detect
2
RD(RXD)
Input
Receive Data
3
SD(TXD)
Output
Send Data
4
ER(DTR)
Output
Data Terminal Ready
5
SG
-
Signal Ground
6
DR(DSR)
Input
Data Set Ready
7
RS(RTS)
Output
Request to Send
8
CS(CTS)
Input
Clear to Send
9
CI(RI)/+5V
Input/-
Called status display
+5V Output 0.5A
Shell
FG
-
Frame Ground
(Common with SG)
(PL unit side)
9
6
5
1