Proface APL3000B - Node Box PC - Manual (Page 23)

PL3000 Series Hardware Manual
1-2
1.1 System Design
The following diagram illustrates the standard range of items that can be connected to PL unit.
PL
Inside of the Control Box
Control Box
Serial ATA I/F
(2 slots)
DVI-I I/F *7
Expansion unit I/F
USB I/F
(4 ports)
Speaker Out I/F
Hub
Speaker
Central Network Line
DIM Module *1 *2
CF Cards *2
Main Memory I/F
(2 slots)
Peripherals
(commercial type)
USB 2.0 compatible peripherals
(commercial type)
Peripherals
(commercial type)
PCI Board
(commercial type)
DVI-D Cable
(optionally available *6
or commercial type)
DVI-I cable
(commercial type)
RGB monitor
(Pro-face FP Series
or commercial type)
DVI monitor
(Pro-face our FP Series
or commercial type)
RGB Cable
(optionally available *6
or commercial type)
Pin-jack Cable
(commercial type)
RS-232C Cable
COM1 *5
COM1/COM2/COM3/COM4 *4
Ethernet I/F
(2 ports)
LAN1: 10BASE-T/100BASE-TX Cable (commercial type)
LAN2: 10BASE-T/100BASE-TX/1000BASE-T Cable (commercial type)
RAS I/F
RAS Cable
(Produces by users)
USB 2.0 Compatible
Peripherals (commercial type)
RS-422 Cable
RS-485 Cable
HDD unit / SSD unit *1 *2
IDE I/F CF
DVI-I - RGB Conversion Cable
(optionally available *2
or commercial type)
DVI-D/RGB Branch Cable
(optionally available *2
or commercial type)
*1 Built-in accessory only
*2 Pro-face's optional devices. Please refer to 1.2 Accessories.
*3 Only when the panel computer is used.
*4 When setting RS-232C mode for COM1.
*5 When setting RS-422 or RS-485 mode for COM1.
*6 Optional device for our FP Series flat panel display.
*7 When the dual output with the front module is selected, the DVI-I can be connected to an analog RGB monitor only.
Front Module *3
USB Interface *3
(1 port)