Proface PS4800 - 19 Panel PC" - Manual (Page 52)

Dimensions/Assembly
52
Industrial Personal Computer Installation
Vibration and Shocks
Take extra care with respect to vibration levels when installing or moving the
Industrial Personal Computer. If the Industrial Personal Computer is moved, for
example, while it is installed in a rack equipped with caster wheels, it can receive
excessive shock and vibration.
Installation Gasket
Use of the installation gasket may help extend the operating life of your Industrial
Personal Computer. The gasket is required to meet the protection ratings (IP65,
IP20) of the Industrial Personal Computer and provides additional protection from
vibration.
Slide-in Disk Drive
NOTE: The Slide-in Disk drive can only be exchanged without removing the
Industrial Personal Computer Unit from the control cabinet if the wall is less than
5.5 mm (0.216 in) thick.
CAUTION
EXCESSIVE VIBRATION
 Plan your installation activities so that shock and vibration tolerances in the unit
are not exceeded.
 Ensure that the installation panel opening and thickness are within the specified
tolerances.
 Before mounting the Industrial Personal Computer into a cabinet or panel,
ensure that the installation gasket is in place. The installation gasket provides
additional protection from vibration.
 Tighten the installation fasteners using a torque of 0.5 Nm (4.5 lb-in).
Failure to follow these instructions can result in injury or equipment damage.
CAUTION
LOSS OF SEAL
 Inspect the gasket prior to installation or reinstallation, and periodically as
required by your operating environment.
 Replace the complete Industrial Personal Computer if visible scratches, tears,
dirt, or excessive wear are noted during inspection.
 Do not stretch the gasket unnecessarily or allow the gasket to contact the
corners or edges of the frame.
 Ensure that the gasket is fully seated in the installation groove.
 Install the Industrial Personal Computer into a panel that is flat and free of
scratches or dents.
 Tighten the installation fasteners using a torque of 0.5 Nm (4.5 lb-in).
Failure to follow these instructions can result in injury or equipment damage.