Proface PS4800 - 19 Panel PC" - Manual (Page 138)

Hardware Modifications
138
7 Install the side cover on the slot expansion using the 4 marked Torx screws
(T10) (2 were removed and 2 are included in the delivery):
8 The Industrial Personal Computer can now be mounted back in the control cab-
inet, see Industrial Personal Computer Installation (see page 52).
CAUTION
OVERTORQUE AND LOOSE HARDWARE
 Do not exert more than 0.5 Nm (4.5 lb-in) of torque when tightening the
installation fastener, enclosure, accessory, or terminal block screws. Tightening
the screws with excessive force can damage the plastic installation fastener.
 When installing or removing screws, ensure that they do not fall inside the
Industrial Personal Computer chassis.
Failure to follow these instructions can result in injury or equipment damage.
Step Action