Proface PS4800 - 19 Panel PC" - Manual (Page 165)

PS-4600 Series User Manual
165
8 If inserting a new main memory card, align the notch on the plug-side of the
memory card with the notch above the slot. The main memory card can now be
carefully pressed into the slot until the fastening clamps are engaged.
1 Slot
2 Memory card
3 Notch above the slot
4 Notch on the plug-side of the memory card
9 The cover plate can now be replaced by following the steps in reverse order.
10 The Industrial Personal Computer can now be mounted back in the control cab-
inet, see Industrial Personal Computer Installation (see page 52).
CAUTION
OVERTORQUE AND LOOSE HARDWARE
 Do not exert more than 0.5 Nm (4.5 lb-in) of torque when tightening the
installation fastener, enclosure, accessory, or terminal block screws. Tightening
the screws with excessive force can damage the plastic installation fastener.
 When installing or removing screws, ensure that they do not fall inside the
Industrial Personal Computer chassis.
Failure to follow these instructions can result in injury or equipment damage.
Step Action