Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 12)

12
13.5 Wiring Precautions
• To help prevent noise and interference problems, separate all control, communication and
power lines by placing them in separate ducts.
If different wires must be placed in the same duct, separate them with a grounded divider.
Model No. Manufacturer Description
Recommended
Cable Connector XM2D-0901 OMRON Co. DSUB 9-pin socket
TSXCANKCDF180T Schneider Electric
Straight connector with
terminal selector switch
TSXCANKCDF90T
TSXCANKCDF90TP
Schneider Electric
Right-angled connector
with terminal selector
switch
VS-09-BU-DSUB/
CAN
PHOENIX CONTACT
Connector with terminal
block and terminal selector
switch
SUBCON-PLUS-CAN/
AX
PHOENIX CONTACT
Straight connector with
terminal selector switch
SUBCON-PLUS-CAN/
PG
SUBCON-PLUS-CAN
PHOENIX CONTACT
Right-angled connector
with terminal selector
switch
CANopen
Recommended
Transfer Cable TSX CAN CA50/TSX
CAN CA100
Schneider Electric
Cable for CANopen
(IEC60332-1) 50m/100m
TSX CAN CB50/TSX
CAN CB100
Schneider Electric
UL-approved cable for
CANopen
(IEC60332-2) 50m/100m
Duct for I/O
Signal Lines Duct for
Control Lines Duct for
Power Lines
I/O Signal
Lines
Control
Lines
Power
Lines
Grounded
Separators
Duct (nonconducting
resin/ plastic)
Ground