Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 55)

Cut to Length with Multi Stroke Program
F4=RETURN TO RAMP COUNT
Pressing the F1-batch counter key allows the operator to preset a batch count.
Pressing the F2-total counter key resets the total count to zero. This cannot
be undone so be sure that the counter should be reset to zero before pressing
F2 key. Pressing the F4 key brings up the following screen.
SELECT RAMP/COUNTERS
F1=BATCH/TOTAL COUNT
F2=ALTER ACCEL/SPEED
F4=EXIT TO MAIN MENU
The only section that has not been covered in this write-up is the ramp adjust
mode. The ramp adjusts how fast the servo motor gets up to speed and how
fast it stops. This feature is an asset that is seldom adjusted but can be a
sure cure if material slippage seems to be a problem. Pressing the F2 (alter
accel/speed) key produces this display.
RAMP PARAMETER MODE
F1=CHANGE % OF ACCEL
F2= CHANGE % OF SPEED
F4=RETURN RAMP/COUNT
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (54 of 66) [12/10/2001 3:44:58 PM]