Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 25)

Cut to Length with Multi Stroke Program
No roll action No air Check air
line
Low air pressure Check air
regulator
Material will not Anti-backup closed Open rolls
enter rolls Feed roll adjusting Open
adjustment
mechanism too close
mechanism
Material too thick Check
servo parameters
Material will not feed Low roller force Raise roller
pressure
Oily material Clean
material
Program fault Check parameters
Obstruction in cutter Check
cutter
Material feeds short Accel to fast Lower accel
speed
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (24 of 66) [12/10/2001 3:44:57 PM]