Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 40)

Cut to Length with Multi Stroke Program
ENTER JOB NUMBER=XX
PRESS F4 KEY ONCE
CORRECT # IS ENTERED
The operator must enter a 2 digit number before proceeding to any other
function. If the job number the operator has entered has been previously
stored in memory, or entering a new job, the following display will appear:
JOB NUMBER-01 LOADED
F1=PROGRAM NEW VALUES
F4= DON’T ALTER VALUES
THAT ARE PREPROGRAMMED
The job number screen displays (2) choices for the operator. In the first
choice, F1=Program new values, the operator can enter or change the
number of sequences, repeats per sequence, pilots, feed length, strokes per
minute that the press is running and feed arc angle. (Free travel of the press
in which the feed can move material without a problem) this then calculates
the optimum speed of the material movement. The second choice, F4= Don’t
alter values that are programmed, puts the job number entered in memory for
running at this time. If F1 was selected the following display would appear.
JOB NUMB=XX ENTER IN
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (39 of 66) [12/10/2001 3:44:58 PM]