Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 26)

Cut to Length with Multi Stroke Program
Low roller force Raise roller
pressure
Oily material Clean
material
Obstruction in cutter Check
cutter
Material feeds long High % max speed Lower % max
feed speed
Material slippery Lower
Decell speed
Decell set too fast Lower
Decell speed.
Material camber High roller force Lower roller
pressure
Bad stock Check
stock at input
TROUBLESHOOTING CHART (cont.)
PROBLEM CAUSE REMEDY
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (25 of 66) [12/10/2001 3:44:57 PM]