Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 27)

Cut to Length with Multi Stroke Program
Material feeds off Edge guides not set Set edge
guides
center properly
Material not centered Center
material
in feed
No automatic cycle No cutter returned signal Check limit
switch
input to
servo control
Controller fault Check
lights on P.C.
Servo fault Check
lights on drive
Program error Check
parameters
Servo squeals while Servo velocity gain Consult
factory
in position too high
Belt too loose or tight Readjust
belt tension
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (26 of 66) [12/10/2001 3:44:57 PM]