Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 51)

Cut to Length with Multi Stroke Program
BATCH COUNTER=000000
F1=RESET BATCH COUNT
F4=COINTINUE WITH COUNT
If F1 (reset batch count) is pressed then the batch count will be reset to it’s
preset valve. If F4 (continue with count) is pressed the batch count will remain
at its present value. Either F1 or F4 will lead to the following screen.
AUTOMATIC CYCLE MODE
JOB =00 NUMBER OF SEQ=00
BATCH COUNTER=000000
F4=EXIT (AUTO CYCLE)
Pressing the F4 key, stops the automatic cycle and the main menu screen
appears. When the automatic screen is displayed, all keys except the F4 key
are inactive. Every time the press cycles and trips the feed switch, the feed
will cycle once per the parameters displayed on the screen. If the feed
encounters excessive material drag while feeding or the material being moved
encounters a restriction that stops the material forward movement then a
servo fault can occur. If this happens then the following screen is displayed.
DRIVE FAULT OCCURED
NOTE TYPE OF FAULT—-
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (50 of 66) [12/10/2001 3:44:58 PM]