Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE User Manual
Page 21
Cut to Length with Multi Stroke Program
being used for forward and F3 for reverse movement. Press F4 to
leave the “inch” mode.
b) Press F2 and the cutter will cycle for the max amount of time
entered. Press F3 and the roll will move the material the feed length
entered and then cut the material when the move is finished.
5. Press “F3” to select automatic cycle. In this mode the servo can be run in
the batch or continuous mode.
a) Press F1 to select the batch mode. In the batch mode, the servo
will feed each time it is commanded until the batch count reaches “0”, then the
automatic cycle drops out.
b) Press F2 to select the continuous mode. In the continuous mode,
the servo will feed each time it is commanded until the command stops
or the operator presses the “F4” return key.
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (20 of 66) [12/10/2001 3:44:57 PM]