Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE User Manual
Page 49
Cut to Length with Multi Stroke Program
F3=AUTOMATIC
CYCLE
If the F2 key was pressed then the servo will be in the auto total mode and the
following screen appears.
AUTOMATIC MODE
JOB =00 NUMBER OF SEQ=00
TOTAL COUNTER=000000
F4=EXIT (AUTO CYCLE)
Pressing the F4 key, stops the automatic cycle and the main menu screen
appears.
MAIN MENU
F1=JOB # F2=MANUAL
F3=AUTOMATIC CYCLE
F4=REVIEW JOB PROGRAM
F3=AUTOMATIC CYCLE
If the feed has been properly set up, tested in manual, press electrically
interlocked with feed, feed and pilot switches wired to the correct terminals,
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (48 of 66) [12/10/2001 3:44:58 PM]