Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE User Manual
Page 22
Cut to Length with Multi Stroke Program
DRIVE ROLL PARALLELISM ADJUSTMENT
Every servo feed has an eccentric adjustment screw to adjust the upper roller
to be in parallel to the lower roller. The maximum adjustment is .008” on the
eccentric.
The adjustment screw is located behind the belt cover and is held fast by a 10-
32 socket head cap screw. The actual adjustment screw is a slotted eccentric
pin which is turned clockwise or counter-clockwise to raise or lower one end of
the upper roll.
The parallel adjustment is factory set when the unit is manufactured but if
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (21 of 66) [12/10/2001 3:44:57 PM]