Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 41)

Cut to Length with Multi Stroke Program
NUMB OF SEQUENCES=XX
PRESS F4 KEY ONCE
CORRECT # IS ENTERED
By definition a sequence is an event. Within a specific job number there is a
maximum of 10 sequences or events. A different sequence could be a new
feed length or a different output or both. After choosing the amount of
sequences then press the F4 key and the following screeen appears.
FEED ADVISOR JOB#=00
FL=000.000 SPM=000
TIME OF CUT = .XXX
F4=EXIT FEED ADVISOR
Input or change data at cursor. At this time, the longest feed length and the
maximum strokes per minute for this job should be entered to test if the feed
parameters are within the specifications of what the feed can perform. When
complete press F4 to exit. A fault window will appear if the feed length is too
long for SPM. Feed arc is press free travel for feeding material. Max feed arc
=300 degrees. The % of speed and then % accel rate is automatically
calculated.
This is the fault window that is displayed if the feed length and strokes per
minute are not within maximum parameters.
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (40 of 66) [12/10/2001 3:44:58 PM]