IEI Integration PPC-5xxx-9455 v1.10 - Manual (Page 137)

PPC-5xxx-9455 Panel PC
Page 119
Î Boot Display Device
Use the Boot Display Device option to select the display device used by the system
when it boots. Configuration options are listed below.
ƒ Auto
ƒ CRT - Default
ƒ TV
ƒ LFP
ƒ CRT + LFP
Î Flat Panel Type [By Jumper]
Use the Flat Panel Type is set using the onboard jumper settings. The jumper settings
can be found in the Installation and Configuration chapter.
Î PID Current Jumper Setting [1-1024x768x24]
The PID Current Jumper Setting shows the current setting of the flat panel resolution
jumper.
Î Internal Graphics Mode Select [Enable, 8 MB]
Use the Internal Graphic Mode Select option to specify the amount of system memory
that can be used by the Internal graphics device.
Î
Disable
Î
Enable, 1 MB 1 MB of memory used by internal graphics device
Î
Enable, 8 MB D EFAULT 8 MB of memory used by internal graphics device
Î
Disabled Scaling is disabled