IEI Integration TANK-820-H61 v2.03 - Manual (Page 37)

TANK-820-H61 Em b e d d e d S ys te m
P a g e 24
Figure 3-9: Mounting Bracket Retention Screws
S te p 3: Secure the brackets to the system by inserting two retention screws into each
bracket (Figure 3-9).
S te p 4: Drill holes in the intended installation surface.
S te p 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
S te p 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.6 Fo o t P a d In s ta lla tio n
The TANK-820-H61 is shipped with four foot pads. To install the foot pads, follow the
instructions below.
S te p 1: Turn the TANK-820-H61 to the left side panel.
S te p 2: Locate the four retention screw holes for the food pad in the bottom surface.
S te p 3: Align the hole of the foot pad with the retention screw holes on the bottom
surface.
S te p 4: Secure the foot pad to the chassis by inserting the retention screw. S te p 0: