IEI Integration KINO-G410 v2.00 - Manual (Page 92)

KINO-G410 Min i-ITX Mo th e rb o a rd
P a g e 80
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
When the Remote Access option is set to Enabled, the following sub-menus appear.
 Serial port number
 Base Address, IRQ
 Serial Port Mode
 Redirection After BIOS POST
 Terminal Type
 Se ria l port numbe r [COM1]
Use the Serial port number option to select the serial port used for remote access.

COM1 D EFAULT System is remotely accessed through COM1
 COM2 System is remotely accessed through COM2

COM3 System is remotely accessed through COM3
 COM4 System is remotely accessed through COM4
 COM5 System is remotely accessed through COM5

COM6 System is remotely accessed through COM6
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
 Ba s e Addre s s , IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
 Se ria l Port Mode [115200 8,n,1]