IEI Integration KINO-G410 v2.00 - Manual (Page 56)

KINO-G410 Min i-ITX Mo th e rb o a rd
P a g e 44
4.4 J u m p e r S e ttin g s
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The KINO-G410 includes one jumper shown in Table 4-1.
De s c rip tio n La b e l Typ e
Clear CMOS jumper J_CMOS1 3-pin header
COM6 function select jumper JP2 8-pin header
Table 4-1: Jumpers
4.4.1 Cle a r CMOS J u m p e r
J u m p e r La b e l: J _CMOS 1
J u m p e r Typ e : 3-pin header
J u m p e r S e ttin g s : See Table 4-2
J u m p e r Lo c a tio n : See Figure 4-8
To reset the BIOS, move the jumper to the "Clear BIOS" position for 3 seconds or more,
and then move back to the default position.