IEI Integration ICE-945GSE v1.11 - Manual (Page 82)

ICE-945GSE COM Express Type 2 Module
Page 70
Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Disabled D EFAULT Remote access is disabled.
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
Serial Port Number [COM1]
Use the Serial Port Number option to select the serial port used for remote access.
COM1 D EFAULT System is remotely accessed through COM1
COM2 System is remotely accessed through COM2
COM3 System is remotely accessed through COM3
COM4 System is remotely accessed through COM4
COM5 System is remotely accessed through COM5
COM6 System is remotely accessed through COM6
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.