Warner Electric Advanced Technology Tension Clutches - Manual (Page 8)

8
Warner Electric • 800-234-3369 819-0339
6. Remove the retainer ring (Item 13). (See Figure
22)
When removing this or other
retaining rings, be sure to hold the retaining
ring with on hand so it will not spring away
and endanger personnel and property should
the pliers lose their grip on the ring. Safety
glasses should always be worn when
installing or removing rings.
7. Remove the field assembly (Item 12) and bearing
(Item 11) by locating and supporting on the rotor
outer diameter (Item 10) and pressing on the hub
(Item 7). (See Figure 23)
8. Remove the bearing (Item 11) from the field
assembly (Item 12) by pressing on the inner race
while supporting the field assembly on its face.
(See Figure 24)
Note: Use caution to avoid damaging the epoxy
covering the coil.
9. Press the new bearing (Item 11) into the field
assembly by pressing on the bearing outer race.
Do not press on the bearing inner race or
damage to the bearing will result, making it
unusable. (See Figure 25)
10. Remove the rotor assembly (Item 10) from the
hub (Item 7). (See Figure 26)
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26