Warner Electric PCBC-500 Clutch_Brake Coupling - Manual (Page 17)

Step 4 Insert the remaining (3) drive pins from the oppo-
site side of the armature hub through the remain-
ing (3) holes.
Note: Apply Grade "AA" Loctite Sealant
on threads of all (6) drive pins. (Figure 8)
Step 5 Holding the pins in position, place the
armature hub over one armature. Make
sure the straight springs on the armature bosses
fit into the groove in the armature hub (Figure 9).
Warner Electric • 800-825-9050 819-0484 17
Armatur e Boss
Armatur e Hub
Drive Pin
Conical
Spring Retainer
Detent Spring
Straight
Spring
Armatur e
The assembly procedure for the autogap accessory is as
follows (refer to Figure 5):
Note: Autogap accessories are shipped
pre-assembled.
Step 1 Place straight springs over armature bosses
on back side of both armatures. (Figure 6)
Step 2 Compress conical spring against retainer ring
by sliding detent spring toward head of pin.
(All 6 pins.) (Figure 7)
Step 3 Insert (3) of the compressed drive pins
through the armature hub. The threaded ends
of the pins must come through on the side of
the hub with grooves around the holes.
Figure 6
Figure 8
Figure 7
Figure 5
Figure 9