Warner Electric EUM-50_EUM-100_EUM-180_EUM-210_EUM-215 User Manual

Page 6

Warner Electric • 800-825-9050

P-226 • 819-0355

and motor. See Figure 8. A pilot diameter on

UniModule mates with a pilot diameter on

Motor Mount.

2. Secure Motor Mount to the UniModule with

three bolts provided and tighten to 40 to 45

ft. lbs. torque.

Figure 8

B. For Washdown Models Only

1. If any mounting bolts are not used, make

sure the mounting holes are plugged with

the .437 diameter plugs provided. For 210

and 215 size units, make sure holes on

circumference are plugged with the .375

plugs provided.

Step7: Electrical Connections

Toavoidinjury(orevendeath)

alwaysmakecertainallpowerisoffbefore

attemptingtoinstallorservicethiscontrolor

anyelectricalequipment.

A. For All UniModule Models

1. The UniModule is provided with one conduit

connection hole, threaded for standard 1/2"

conduit connectors. Both the clutch and

brake lead wires are brought out through

this opening. The conduit box accessory kit,

P/N 5370-101-042 for non-washdown

models, and 5370-101-045 for washdown

models, provides two conduit connection

holes for standard 1/2" conduit connectors.
The clutch and brake coils operate on DC

voltage. Warner Electric offers a full line of

AC voltage powered controls to meet the

needs of almost every clutch/brake

application. The service and installation

instructions included with each Warner

Electric control show the proper electrical

connections.
Please refer to Figure 9 for the proper

UniModule electrical connections. Clutch

andbrakeleadsareidentifiedwith

labels.

B. For Washdown Model Only

1. Use only liquid tight connectors with flexible

tubing for connections.

Figure 9

After wiring, your Enclosed UniModule is now

ready to operate. If your clutch/brake control has

torque control, the torque adjust potentiometer(s)

should be set for rapid and complete load take

up. Excessive slippage of the brake or clutch can

cause overheating and premature wear. For

additional information, including the armature

adjustment which is occasionally required for

new installations, see page 7 of this manual.

Clutch/Brake

Control

Clutch

Brake

White

Black

Red

Black

Voltage