Teledyne LeCroy ADP300_305 - Manual (Page 34)

ADP30x Probe
Safety Compliance
EC D
ECLARATION OF
C
ONFORMITY
– L
OW
V
OLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular requirements
for testing and measuring circuits
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
• Measurement Category III (CAT III), for measurements performed in the
building installation.
• Measurement Category II (CAT II), for measurements performed on
circuits directly connected to the low-voltage installation.
• Pollution Degree 2, operating environment where normally only dry
non-conductive pollution occurs. Conductivity caused by temporary
condensation should be expected.
Environmental Compliance
E
ND
-O
F
-L
IFE
H
ANDLING
The probe is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary
by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For
more information about proper disposal and recycling of your Teledyne LeCroy
product, please visit teledynelecroy.com/recycle.
30 923079-00 Rev A