Teledyne LeCroy ADP300_305 - Manual (Page 18)

ADP30x Probe
Probe Auto Zero
PRx:AUTOZERO, PRx:AZ
Command
Description The PRx:AUTOZERO command initiates an auto zero cycle in the
ADP30x probe to remove any offset drift. The probe input can
remain connected to the test circuit during the auto zero cycle.
Command Syntax
:AutoZero
:= {PR1, PR2, PR3, PR4}
Example The following command initiates an auto zero in the ADP30x
Differential Probe attached to channel 1:
CMD$="PR1:AZ":CALL IBWRT(SCOPE%,CMD$)
Probe Bandwidth Limit
PRx:BANDWIDTH_LIMIT, PRx:BWL
Command/Query
Description The PRx:BANDWIDTH_LIMIT command sets the upper (HF) –3
dB bandwidth limit of the ADP305 probe. The arguments are in Hz.
The PRx:Bandwidth_Limit query returns the upper bandwidth
limit setting for the differential probe connected to the specified
channel.
Command Syntax
:BWL
:={PR1, PR2, PR3, PR4}
:={OFF, 20M}
Query Syntax
:BWL?
Response Format
:BWL
Example The following command sets the upper bandwidth of the ADP305
connected to channel 1 to 20 MHz.
CMD$="PR1:BWL 20M": CALL IBWRT(SCOPE%,CMD$)
NOTE: The PRx:Bandwidth_Limit command is not available with model ADP300.
14 923079-00 Rev A