Ir pass-through installation and setup, Ir signal tip gnd (ground) ring – Staub Electronics B-500-MTRX-230-8X16 BINARY - HDMI 8X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS User Manual

Page 14

B-500-MTRX-230 Installation Manual

Pg. 14

™

7.8. IR Pass-Through Installation and Setup

To utilize IR pass-through between a display location and the matrix switcher, install a B-500-RX-230-IR at the display

and use HDBaseT for routing the signal. The matrix switcher and the matrix receiver are equipped with ports to allow

commands to be sent to the display or from the display area. This section details the pinouts and correct use of the IR

pass-through ports.

7.8.1. Matrix Switcher IR Connections

The ports indicated in the diagram are described in detail below. Guides for standard applications are included on the

following pages for reference during setup.

7.8.2. Matrix Switcher IR Port Configuration

All IR connection ports on the B-500-MTRX-230 are 3.5mm mono mini and use this pinout configuration. Consult with

the manufacturer of any attached IR equipment to confirm their pinout matches before use.

1. System All IR Out

This port repeats any command sent from the IR Receiver ports on B-500-RX-230-IR Matrix Receivers connected

to any HDBaseT output.

2. System IR In

3.5mm mono mini IR input port for matrix switcher IR control.

3. System Input Legend

Printed diagram to indicate input and IR connection numbering.

4. IR Output to Source 1 through 16

The IR output from each connected B-500-RX-230-IR is transmitted to the IR OUTPUT TO SOURCE ports.

Commands can be routed to the source selected or to the like-numbered port.

5. IR Input to Room 1 through 16

Use 3.5mm mini-mono cables to connect IR flasher outputs on a control system to these ports to send commands

to displays or equipment located at the B-500-RX-230-IR matrix receiver location. The number corresponds to the

output zone number, so IR Input to Room port 1 will send signals to HDBaseT output 1.

IR Signal (Tip)

GND (Sleeve)

IR Signal

Tip

GND (Ground)

Ring

12V DC 11.2A

INPUT

IR INPUT

TO ROOM

IR INPUT

TO ROOM

IR OUTPUT

TO SOURCE

IR OUTPUT

TO SOURCE

1
2

3
4

5
6

7
8

11
12

13
14

15
16

1
2

3
4

5
6

7
8

11
12

13
14

15
16

UTPUTS

12V DC 11.2A

INPUT

LINK

1 2

This manual is related to the following products:

B-500-MTRX-230-16X16 BINARY - HDMI 16X16 MATRIX SWITCH WITH HDMI AND HDBASET OUTPUTS