IAI America RCS2-RTC12L - Manual (Page 25)

19
3. Installation Environment, Storage/Preservation Environment
3. Installation Environment, Storage/Preservation Environment
3.1 Installation Environment
Install the actuator in an environment meeting the conditions listed below.
x not be exposed to direct sunlight.
x be free from irradiating heat coming from a heat treatment furnace or other equipment that generates a
large amount of heat.
x have surrounding air temperature of 0 to 40qC.
x have humidity of 85% or below (non-condensing).
x be free from corrosive or flammable gases.
x be free from excessive dust and suitable for normal assembly work.
x be free from oil mist or cutting oil.
x be free from impact or vibration.
x be free from strong electromagnetic field, ultraviolet light or radiation.
x Chemical resistance is not considered in the design of this product.
In general, the actuator should be used in an environment where the operators can work without wearing
any protective equipment or gear.
3.2 Storage Environment/Preservation
The storage/preservation environment conforms to the installation environment. If the robot is to be
stored/preserved for a prolonged period of time, be sure the robot will not be exposed to condensation.
Unless otherwise specified, desiccant is not placed in the carton when shipped. If the robot is to be
stored/preserved in an environment subject to condensation, provide preventive measures from over the
carton or directly to the robot after unpacking.
The maximum storage/preservation temperature is 60
qC for a short storage period. If the robot is to be
stored/preserved for more than a month, the temperature should not exceed 50
qC.