IAI America RCP2W-SA16C - Manual (Page 15)

9
10. Do not perform a pressing operation. Also, do not apply an excessive
impact on the slider such as by hitting it with a hammer, etc.
Since the ball screw nut and the slider are joined together via a pipe material by magnetic
force, the ball screw and slider may get separated out of the magnetic joint if an excessive
impact is applied to them, resulting in such a problem as the actuator to malfunction.
11. Do not attempt to apply high-pressurized water directly to the filter
parts or to prick it with a sharp-edged object.
Although the ball screw and the motor part are made airtight in the pipe and the casing to
prevent water and dust, there is a filter made by Gore-Tex equipped on the motor case and
edges of the pipe to avoid pressure differences between the inside and outside and
condensation. By putting high-pressurized water directly or pricking with a sharp-edged
object to this part, it may cause a peel or make a hole on the filter, which may result in a loss
of the drop-proof function.
Filters