SecurityMan IPcam-SD - User manual - Manual (Page 9)

5
Product Basics
Infrared LEDs
Light Sensor
Camera Lens
Front View
Network Port Antenna Mount Micro SD Slot
Power Socket Alarm In/Out Speaker Microphone
Rear View
Bottom View
Mounting Hole Reset Button
Base
NOTE: The reset button located at the bottom of the camera is used to reset the
IPcam-SD to its original “factory default” settings. To apply, power up your camera
then press and hold-in the reset button using a small non-pointed/non-metallic
instrument (paper clip or other stationary) for 5 seconds.