Securitron DK-37 - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2013, all rights reserved PN# 500-20750
Page 1 Rev. A, 11/13
DK-37 Installation & Operating Instructions
Introduction
The DK-37 Digital Keypads by Securitron offer Wiegand output for universal compatibility with
access control systems or the Securitron Digital Keypad Controller (DKC). The outdoor-rated 12
key stainless steel 2”x6” keypad features silicone rubber keys.
DK-37 keypads are shipped in ‘Wiegand mode’ from the factory. When interfacing with
the DKC, please change the keypad to ‘Character mode’ and ensure that ‘Character’ is
selected in the DKC Programming Tool. The advanced programming features available
in Character mode allow a user to customize the operation of the DKC to fit the specific
needs of their installation. Instructions on how to change from Wiegand to Character
mode are found in the Changing to Character Mode section below.
Box Contents
Keypad with 16’ of cable
Installation & Operating Instructions
Mounting hardware pack
 (2) #8 X 1-1/2” Screw  (1) T-Nut
 (1) 8-32 X 3/8” Phillips Pan Head Screw  (1) Mounting Bracket
 (1) 8-32 X 3/8” Spanner Pan Head Screw  (1) Name Plate Label
Tools Needed
 Drill with 3/8” and 1/8” Drill Bits
 Phillips and (optional) Spanner Screwdriver
Specifications
Power Requirements
Input Voltage Active Amperage Resting Amperage
12 VDC 35 mA 7 mA
24 VDC 75 mA 16 mA
Environmental
Operating temperature: -22° to 158°F (-30° to 70°C) for indoor or outdoor use
Installation
Drill a 3/8” diameter hole in the wall through which the wires will be routed. Drill two 1/8”
diameter holes for the #8 mounting plate screws as shown in Figure 1.
Figure 1 – Hole locations