Securitron GL1 Install - Manual (Page 2)

PN# 500-22100
Page 2 Rev. F, 04/11
B. Protection of the lock from external attack:
The lock and the wiring must be protected to a reasonable degree from potential damage
due to intruders or vandals.
C. Convenience and accessibility of area to be protected:
The lock assembly should be installed in a location that will not hinder or create a potential
safety hazard to authorized personnel routinely accessing the protected area.
Because of the diversity in gate construction and installation configurations, optimum mounting
platforms may be achieved by welding adequate size metal plates, channels or tubing to the
fence frame and the gate. Formed angle and brackets along with appropriately sized fasteners
may also be utilized to mechanically secure mounting platforms for the lock and strike.
Mounting bracket kits such as the FMK-SL (Sliding Gate) and the FMK-SW
(Swing Gate) are recommended for installing the GL1 on your gate.
INSTALLATION WARNINGS:
1. The lock must be mounted in the upright vertical or horizontal position.
2. Make sure all welding is completed prior to making any electrical connections
to the mounted lock. Welding in or around a lock assembly that is connected
electrically can cause damage to the electronic components.
3. Not recommended for dual swing gates.
The following illustrations show some basic mounting configurations on a chain-link style fence
frame and gate:
Swinging Gate Mount
Sliding Gate Mount