Reese 59772 ROOF RACK ACCESSORY - Manual (Page 3)

M8 Bolt
Spring Washer
M8 Washer
M8 Nut
End Cap
Cross Bar
Clamp Plate
Cross Bar shortened for
illustrative purposes
Fig. 11
Fig. 10
PART No:
CARRYING CAPACITY:
Pg 3 of 3 Printed in China
A number of accessories for carrying special loads are available.
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the cross bars.
REGULARLY CHECK THE TIGHTNESS OF CROSS BAR & ATTACHMENTS.
Loads should be evenly distributed and secured .
Check the function of all doors and sunroof before driving .
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle
should therefore be driven with increased caution.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit: www.rolaproducts.com .
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
Step 8: Install End Caps
Locking End Caps can now be installed into the ends
of the cross bars. (Fig. 13) Remove keys and keep in
a safe place.
To load accessories into the Cross Bar accessory
channel remove End Cap, cut Buffer Strips as needed.
Once accessories have been loaded, re-insert the End
Caps and lock. Additional Buffer Strips may be
purchased from ROLA if needed.
Slide to end
Caution sharp
edges
Inner Under
Cover strip
Outer Under
Cover strip
Fig. 12
Fitting Instructions
APE (Anchor Point Extended)
Cross Bar Kits for Track & Direct
Mounting Systems
59772, 59773,
59774
Step 6: Fitting Cross Bars to the vehicle
A. Place the Cross Bar onto the End Supports
ensuring that the End Support Tabs are located
into the cutouts on the underside of the bar.
Ensure the Cross Bar marked “FRONT” is
placed on the front End Supports. Check that
the Cross Bar has equally distanced overhang
on either side of the End Supports. (Fig. 10)
B. Insert the M8 hex nut into the Clamp Plate.
Insert the Clamp Plate into the end of the Cross
Bar and align it so that the nut and the End
Support’s bolt hole align.
C. Secure the Cross Bar to the End Support by
screwing the M8 x 20mm bolt with Washer and
Spring Washer through the End Support hole
and into the Clamp Plate nut. (Fig. 11)
D. Using a 13mm or adjustable wrench fully
tighten the bolt on the underside of the
support. Now using the Security Key finish
tightening the M6x16 bolts to 5Nm (44 in/ lbs)
or to a firm hand tightness.
Step 7: Installing Under Cover strips
Mark on underside of bars with a pencil the length
of Under Cover strips needed.
Remove bars, measure length of under cover filler
strips to fill slot. Cut Under Cover pieces using
scissors or a blade. Slide inner most Under Cover
into position on the bars and re-assemble bars
onto vehicle. Add the outer Under Cover piece
once bars are attached. (Fig. 12)
Fig. 13
59772-3-4N REV 4-24-13
75Kgs/
165 Lbs
End Cap
Tabs