Reese 30143 25K ELITE SERIES - Manual (Page 6)

Figure 8: Anchor Tee Pin and Handle Orientation ( all shown in unlocked position )
8C) The pin will snug up at an
undetermined angle 8D) Loosen Tee Pin back to first
parallel with bushing position(less
than ½ rotation) 8E) Loosen Tee Pin 1 additional
complete rotation for suggested
adjustment.
Figure 9 : Inserting Lynch Pin
9C) When inserted snap Lynch Pin
Ring down over Handle Nut
9B) Lynch Pin inserts through
grove and hole 9A) Hole in top of Tee Pin will
align with Handle Nut groove
WARNING:
Failure to properly install handles
could result in tow vehicle damage or
truck and trailer separation.
7. Replace unit into pucks with all handles in unlocked position (see Figures 10A and 10B). Rotate handles into locked
position. It is normal for some of the handles to have very little or no resistance; while others have a moderate amount of
resistance when locking. Should a handle not be able to be locked by hand it needs to be adjusted, see Note D.
NOTE D: To adjust handle tension when locking first remove hitch from pucks. Next, while keeping the handle to
tee pin orientation, remove the lynch pin. Rotate the tee pin counterclockwise ½ rotation, and replace lynch pin.
Conversely, if there is too much clearance in the attachments when locked, the clearance can be removed by
rotating the tee pin clockwise ½ rotation, and replacing the lynch pin.
( )
30143IN – 12JAN10A PCN12853 2010 CEQUENT PERFORMANCE PRODUCTS, INC LITHO IN USA
FOR KITS 30142 & 30143
6
8. Remove hitch assembly and lube (lithium grease) tee pins in bushings, replace unit in pucks.
9. Lock handles through arches on both sides and place lynch pins through overlapping handle holes (see Figure 11).