Warning – Reese 30143 25K ELITE SERIES User Manual

Page 13

IMPORTANT: YOU ARE RESPONSIBLE FOR SAFE HITCHING AND UNHITCHING OPERATIONS. DO NOT RELY ON

OTHERS TO PERFORM THESE DUTIES. YOU MUST PERSONALLY MAKE SURE THE FOLLOWING
STEPS ARE PERFORMED IN THE FOLLOWING ORDER!

WARNING:

FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN DEATH OR SERIOUS INJURY.

HITCHING PROCEDURE:

1. Place blocks (sometimes called “chocks”) firmly against front and rear of each trailer wheel to prevent any possible

forward or rearward motion. DO NOT REMOVE BLOCKS UNTIL EACH OF THE FOLLOWING STEPS AND THE
PULL TEST HAVE BEEN COMPLETED. Lower tailgate if necessary. Clearance of the lowered tailgate to the trailer needs
to be monitored during hookups as some manufacturer combinations of truck and trailer have little or no clearance.

2. Using trailer jacks, adjust trailer height following the directions in the trailer manual so that bottom of trailer pin box (“A” in

Figure 24) is ½ to 1 inch below skid plate (See “B” in Figure 24). During the hitching maneuver, the bottom of the trailer

i b

ith kid l t

(“C” i Fi

24)

Bottom of Pin Box (A)
1/2 To 1 Inch Below
Hitch Skid Plate (B)

Hitch Skid Plate (B)

pin box should come in contact with skid plate ramp (“C” in Figure 24).

Bottom of

Box Above

WARNING:

Failure to follow this instruction may result in king pin being too high and coming to rest on top of closed jaws or
not completely inside jaw (Figure 25) This could result in trailer separating from hitch Trailer separation may

Figure 24

CORRECT

Skid Plate Ramp (C)

Bottom of Pin Box (A)

Box Above

Hitch Skid

Plate

Figure 25

WRONG

not completely inside jaw. (Figure 25). This could result in trailer separating from hitch. Trailer separation may
result in death or serious injury if anyone is under the trailer or between truck and trailer when separation occurs.

3. Remove bail pin from bail pin hole(see Figure 26). Then pull handle out and rearward to hold open.

NOTE:

Hitch jaw must be in the open position for king pin to enter the hitch.

Hitch Jaw

Handle

Bail Pin Hole

Figure 26

King pin

Pull handle out
and latch to the
rear to open
hitch jaw

4. With handle in the open position (See Figure 26), back truck slowly into trailer. As king pin completely enters
head, jaw will spring closed around king pin and handle will return to the closed position. If the handle does not
return to the closed position, then
try to push the handle back to the
closed position. If handle does
not return to the closed position
then move the truck slightly forward
or rearward until the handle returns

g p

30143IN – 12JAN10A PCN12853 2010 CEQUENT PERFORMANCE PRODUCTS, INC

LITHO IN USA

FOR KITS 30142 & 30143

to the closed position. (See Figure 27)

5. Use only the method described above for hitching. Figure 27

Flag