Reese 33058 PROFESSIONAL RECEIVER User Manual
Installation instructions, Part numbers
Installation Instructions
Ford Ranger, Mazda B2300,
Mazda B3000, Mazda B4000
Part Numbers:
75082
33058
78165
87161
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 19mm, 7/8”
Drill Bits: ½”
1.
For vehicles with step bumper, remove rearmost bumper bracket bolt and J-nut (both sides).
2.
Position hitch on vehicle, sandwiching bumper brackets (if present) between hitch and vehicle frame. Install rearmost fasteners.
3.
Using hitch as a template, drill (2) ½” holes into frame at forward end of hitch.
Note: On some models, holes may already exist.
4.
Install remaining fasteners as shown. For vehicles with step bumper, place 3/16 x 1 x 2 block (Item 5) between frame and side
brackets at forward attachment as shown.
Rev. B
11/21/07
N75082
Sheet 1 of 3
z
2002, 2006 Cequent Towing Products
Lock Washer ½”
Qty. (4)
3
3
3
3
Block 3/16” x 1” x 2”
Qty. (2)
5
5
5
5
Block ¼” x 1” x 2”
Qty. (4)
2
2
2
2
Hex Nut – ½-13
Qty. (4)
4
4
4
4
Carriage Bolt ½-13 x 1-3/4”
Qty. (4)
1
1
1
1
Tighten all ½” GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: F75082
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
400 (182 Kg)
4000 (1 816 Kg)
Weight Carrying
Ball Mount
750 (340.5 Kg)
6000 (2 724 Kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU3
Form: F205 Rev A 5-6-05
Bumper
Frame Rail
Bumper
Bracket
5
5
5
5
Bumper
Bracket
Frame rail
Existing Bumper
Bracket Fasteners
Rearmost to be Removed
97 and Prior Models
Note: 19mm open end style wrench
must be purchased to allow
removal of spare tire after
hitch installation.
Place between frame and hitch
if vehicle is equipped with step
bumper
12
12
12
12
34
34
34
34
43
43
43
43
43
43
43
43
34
34
34
34
Note: Relocation of spare tire bracket is NOT required.