Ransburg Vector R Series Cascade 79523 R90 Waterborne - Manual (Page 50)

1
Vector R Series Cascade Applicators - Maintenance
Ransburg
46
Figure 34: Fluid Bracket Removal
Figure 35: Trigger Shelf Removal
Figure 36: Trigger Stop Removal
6. Remove the air inlet fitting and the fluid bracket
from the base of the applicator.
7. Remove the trigger shelf by removing the set
screw with a 3/32" Allen wrench. Push down on
the shelf to remove.
8. Remove the trigger stop by turning the knob
of the stop counter-clockwise until the thread of
the stop is completely disengaged.
1 - Fluid Bracket
2 - Air Inlet Solvent Proof O-Ring
3 - Air Inlet Fitting
1 - Finger Shelf Set Screw
2 - Finger Shelf (pushed down)
1 - Trigger Stop Assembly
Reassembly
(Refer to Figures 31, 32, 33, 34, 35, 36,
37, and 38)
1. Screw the trigger stop into the handle in a
clockwise direction.
2. Push the finger shelf up on the dovetail pad
on the handle to the desired height, insert the set
screw and tighten with a 3/32" Allen wrench.
3. Insert the fluid bracket over the air fitting, then
install the o-ring over the air fitting. Tighten the
air fitting in a clockwise direction.
1
2
3
1
2
AH-06-01.13