Gentec-EO UP and XLP12 - Manual (Page 30)

Version 5.0
Ultra Series UP Instruction Manual Gentec Electro-Optics Inc. All rights reserved
26
1.5 UP POTENTIOMETER POSITIONS
The UP with amplification has 3 holes on top of the detector for the UP12E, UP19K and the UP25T
and on the left side of the detector for the UP25N(M), UP50N(M), UP55N(M) and the UP60N(M)
giving access to the potentiometers to adjust the gain, the anticipation and the offset, as shown in
figure 1-8.
WARNING : If you are using Gentec-EO calibration, DO NOT change the
potentiometer settings because this would invalidate factory calibration.
FIG. 1-11 POTENTIOMETER POSITIONS