Teledyne BDS-3000 - Oxygen analyzer - Manual (Page 8)

BDS 3000
Teledyne Analytical Instruments viii
3.3.1 Gas Connections 21
3.3.2 Electrical Connections 22
3.3.2.1 Primary Input Power 22
3.3.2.2 50-Pin Equipment Interface Connector 23
3.4 Electrolyte Refill of BDS Sensor 28
3.5 Testing the System 30
3.6 Sensor Protection Mode 30
Operation ..................................................................................... 33
4.1 Introduction 33
4.2 Using Data Entry and Function Buttons 34
4.3 The System Function 36
4.3.1 Tracking Oxygen During Cal and Alarm Delay 37
4.3.2 Setting up an Auto-Cal 38
4.3.3 Password Protection 39
4.3.3.1 Entering the Password 40
4.3.3.2 Installing or Changing the Password 41
4.3.4 Logout 43
4.3.5 System Self-Diagnostic Test 43
4.3.6 Version Screen 44
4.3.7 Filter Function 44
4.3.8 Negative Value Display 45
4.3.9 The Gas Correction Factor 45
4.3.10 Troubleshooting Screen 46
4.3.11 Temperature 47
4.3.12 Extended Analog Output Function 47
4.3.13 Zero Baseline Temperature Compensation 48
4.4 Calibration of the Analyzer 49
4.4.1 Zero Cal 50
4.4.1.1 Auto Mode Zeroing 50
4.4.1.2 Manual Mode Zeroing 51
4.4.2 Span Cal 52
4.4.2.1 Auto Mode Spanning 52