PROLiNK WNR1004 Wireless-N User manual - Manual (Page 5)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
2
1.2 Physical Details
1.2.1 Front LEDs
LED Behavior
LED Printed Color Behavior Indication
ON Power on
Power Green
OFF Power off
ON WPS function on
OFF WPS function off WPS Green
Blinking WPS is enabled to make a connection
OFF WLAN off
ON WLAN link / active Wireless LAN Green
Blinking WLAN traffic transmitting
1.2.2 Rear Panel
Reset
Keep on pressing the Reset button more than 3 seconds, the Wireless
Portable Router will set all setting back to factory default values.
WPS
To enable the WPS function via web configuration (Wireless Settings>
WPS), then press the WPS button once on the Wireless Portable Router,
the GREEN LED will start to flash. To make a connection with other WPS
supported device within 2 minutes.
WAN
Connect the ADSL or Cable Modem here with RJ45 cable. If your modem
came with a cable, use the supplied cable, otherwise, use a standard
LAN cable.
LAN
Use standard LAN cables (RJ45 connectors) to connect your PCs to the
port. If required, any port can be connected to another hub. Any LAN
port will automatically function as an "Uplink" port when necessary.
DC 3.3V/1.5A Connect the power supply adapter here.