PROLiNK WNR1004 Wireless-N User manual - Manual (Page 43)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
40
3.5.2.9 Wi-Fi Protected Setup (STA)
This page allows you to use the setting for WPS (Wi-Fi Protected Setup). Using this feature could let your
wireless client atomically synchronizes its setting and connect to the Access Point in a minute without any
hassle.
WPS AP Site Survey Display the information of surrounding APs with WPS function from last scan result.
List information included SSID, BSSID, RSSI, Channel, Authentication, Encryption,
Version, and Status.
Refresh Issue a rescan command to wireless NIC to update information on surrounding
wireless network.
Mode Select from the pull-down menu to decide the station role-playing as an Enrollee or
an external Registrar.
Registrar: Add the AP’s PIN code into the PIN code column, and press the device PIN
button. It will connect with the AP in 2 minutes and get IP address.
Enrollee: Input the device’s PIN code into the PIN code column of AP. Start AP WPS
process and click device PIN button. Then, the device will connect to AP in two
minutes and get IP address.
PIN Start It is required to enter PIN (Personal Identification Number) Code (8-digit numbers)
into Registrar when using PIN method. When STA is Enrollee, users can use "Renew
PIN" button to re-generate new PIN Code.
PBC Start Push Button Communication. Click Start PBC button to make a WPS connection within
2 minutes.
Cancel Click Cancel button to discard the WPS connection.
WPS Status Here shows the current status of the WPS function.