PROLiNK WNR1004 Wireless-N User manual - Manual (Page 34)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
31
b) Bridge Mode
If the Bridge mode be selected, set up Wireless MAC address to each other to enable WDS function.
Phy Mode Select CCK, OFDM, HTMIX or GREENFIELD from the pull-down menu. Each AP
should be setup to the same Phy mode.
AP1~AP4 Encrypt Type Users should go to the main web page of the Wireless Portable Router Wireless
settings > Security page to set up security mode under Open, Shared, WEP
Auto, WPA, WPA-PSK, WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK, WPA/WPA2.
Select NONE, WEP, TKIP and AES encryption type from pull-down menu.
(Default encryption type is NONE.)
Encrypt Key Enter the corresponding encryption keys in the field.
Select the type of Open, Shared, WEP Auto authentication, for WEP encryption.
• Hexadecimal (WEP 64 bits) : 10 Hex characters (0~9, a~f).
• Hexadecimal (WEP 128 bits) : 26 Hex characters (0~9, a~f).
• ASCII (WEP 64 bits) : 5 ASCII characters (case-sensitive).
• ASCII (WEP 128 bits) : 13 ASCII characters (case-sensitive).
Select the type WPA, WPA-PSK, WPA2, WPA2-PSK, WPA-PSK/ WPA2-PSK,
WPA/WPA2 authentication, for TKIP or AES encryption.
If users select TKIP or AES encryption, please enter the password in the
Encryption Key column that must be filled with characters longer than 8 and less
than 64 lengths to set up the security.
AP1~AP4 MAC Address Enter Wireless MAC of each other to make the WDS connection.