PROLiNK WNR1004 Wireless-N User manual - Manual (Page 22)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
19
Select Enabled or Disabled from the pull-down menu.
IPSec Passthrough IPSec, Internet Protocol Security. Select Enabled or Disabled from the pull-down menu.
PPTP Passthrough PPTP, Point-to-Point Tunneling Protocol. Select Enabled or Disabled from the pull-
down menu.
3.4.5 Advanced Routing (Gateway Mode)
If you connect several routers with this Wireless
Portable Router, you may need to set up a
predefined routing rule to have more effective
network topology/traffic, this is called static route
between those routers and the Wireless Portable
Router.
To set static routers, enter the settings including
route IP address, route mask route gateway the
route Interface from LAN or WAN.
Destination
The network address of the destination LAN segment. When a packet with
destination IP address that matches to this field, it will route to the device set in
the Route Gateway field.
Range Select Host or Net from the pull-down menu.
Gateway Enter the Gateway IP address in the field.
Interface You can select to use LAN, WAN or Custom as the physical interface from
where the packets will be sent.
Comment Enter note or remark here.
Dynamic Routing Settings Select Disable or Enable form pull-dowm list to use the RIP function.
Apply After completing the settings on this page, click Apply button to save the
settings.
Reset Click to discard current setting.