PROLiNK WNR1004 Wireless-N User manual - Manual (Page 42)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
39
Direct Link Setup Check the box to enable Direct Link Setup (DLS) and enter the MAC address in below
column. This function will be enabled under the connection with AP which must
support the DLS function. Direct Link Setup allows direct STA-to-STA frame transfer
within a BSS (Basic Service Set). This is designed for consumer use, where STA-to-STA
transfer is more commonly used.
Tear Down Click the Tear Down button to disable the DLS function.
3.5.2.7 Station 11n Configurations
MPDU Aggregation Check the box to enable this function. (Default setting is Disable.) Select Manual or
Auto to set up the MPDU density form 0~7. Default setting is Auto.
Aggregation MSDU
(A-MSDU)
Check the box to enable this function. (Default setting is Disable.)
3.5.2.8 Station About
Here shows the information of the station.