Diamond Products SK-B - Manual (Page 37)

Wire sawing system
6.% 7KH GLDPRQG ZLUH
SK-B_0008_e.mif page 37
12.2 Preparing the ends of the wires
Steps for both wire types
6HSDUDWH WKH ZLUH ZLWK D FXWWLQJRII ZKHHO RQH EHDG
LV DOZD\V ORVW VHH SDJH
5HPRYH WKH VWHHO VSULQJ ZLWK VLGH FXWWLQJ SOLHUV
&OHDQO\ UHPRYH WKH SODVWLF FDVLQJ IURP WKH VWHHO ZLUH
ZLWK NQLIH
Only use a right-angle grinder with a 1.6 mm
cutting-off wheel for separating the wire.
&XWWLQJRII ZKHHO
12.3 Avoiding non-circular wear
Turn the wire
In order to prevent non-circular wear of the
diamond beads, both wire types must be
turned before connection in an anti-clockwise
direction.
.QXFNOH OLQN WXUQ DIWHU SUHVVLQJ
5HSDLU VOHHYH WXUQ EHIRUH SUHVVLQJ
The steel wire must be absolutely free from
plastic residues before pressing. The wire
would otherwise be torn out of the pressing.
Caution, danger of cuts: When
using the knife, make sure to cut
away from your hand.
Separating with other tools is not
recommended as the ends of the wire are
not precisely cut at the correct angle.
With short wire contact lengths special care
must be taken, as non-circular wear of the
wire is particularly easy with such
applications.
Do not exert excessive tension on the wire!