Diamond Products SK-B - Manual (Page 17)

Wire sawing system
6.% :DWHU
SK-B_0008_e.mif page 17
Connect the water supply
3UHVVXUH EDU PLQ WR EDU PD[
:DWHU WHPSHUDWXUH ƒ& PD[
0DNH VXUH WKDW WKH ZDWHU VXSSO\ FDQQRW EH WXUQHG RII
DFFLGHQWDOO\ ZKLOH \RX DUH PDFKLQLQJ
Blow out water in the event of risk of frost
l Disconnect the water supply hose from the
power unit employed
l Disconnect the water lances (A) and blow
through
l Open the water tap (1a)
l Blow through the flexible water pipe (B) and
the rigid water pipe (C)
l Blow through the water hose in the hose
package of the power unit or electric motor
l Blow through the water supply hoses
Never turn off the water supply during
machining.
To prevent frost damage, the entire water
system must be emptied and blown out
when work has been completed and prior to
prolonged breaks in work.
Also refer to the operating manual of the
power unit employed.