Diamond Products SK-B - Manual (Page 31)

Wire sawing system
6.% &RQQHFWLQJ WKH 6.%
SK-B_0008_e.mif page 31
11 Connecting the SK-B
Initial start-up
The SK-B is ready for operation when
delivered. The instructions in the section
"Preparatory work" also apply for the initial
start-up of a new machine.
Preparatory work
Always proceed as follows:
l Determine the basic conditions
l Secure the site
l Determine the position and sequence of the
drilled holes and cuts see “Correct cutting
direction” on page 21.
l Perform inspection work
l Cover sharp-edged friction areas (hoses
and cables)
Visual inspection
Check:
2LO OHYHO LQ WKH RLO WDQN RI WKH SRZHU XQLW
/HDNLQJ RLO IURP KRVHV DQG FRXSOLQJV
&RXSOLQJV IRU GDPDJH DQG VRLOLQJ
+RVHV FRQQHFWRUV DQG FDEOHV IRU GDPDJH
7RRWKHG UDFN RI WKH GULOO VWDQG PXVW EH FOHDQ
11.1 Connecting the main and feed
circuits
Refer to the operating manual of the power
unit employed.
Make sure that you are
positioned at a sufficient distance
from the unit and not in the "line
of fire" of the wire. If the wire
breaks, you will then be more
effectively protected.