Magnum Venus Plastech CB-5000-PRX RTM Control Box - Manual (Page 9)

9
Plug Disassembly:
1. Remove the four screws holding the outer shell of the plug together.
2. Remove the inner guard from the plug shell. Remember to put the tubing thru the inner
guard before connecting it to the barb fitting.
Shift Valve Supply:
3. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #1 barb fitting. (see diagram
above)
4. Push the other end of the poly tube into the push fitting located on the bottom side of
the air motor valve.
Solvent Tank Pressure:
5. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #2 barb fitting. (see diagram
above)
6. Attach the other end of the poly tube
to the Flush Tank on the side marked as “AIR”.
Vacuum Assist Valve:
7. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #3 barb fitting (Vacuum
Valve “OFF” signal). (see diagram above)
8. Push the other end into the push fitting located at the top of the Vacuum Assist Valve.
(see drawing below)
9. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #4 barb fitting (Vacuum
Valve “ON” signal). (see diagram above)
10. Push the other end into the push fitting located on the bottom of the air cylinder of the
Vacuum Assist Valve, just below the “OFF” signal. (see drawing below)
Air Purge:
11. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #5 barb fitting (Air Purge).
(see diagram above)
12. Push the other end into the push fitting located at the top of air purge portion of the RTM
Flush Valve mounted on the gun. (see drawing below)