Magnum Venus Plastech CB-5000-PRX RTM Control Box - Manual (Page 10)

10
Solvent Purge:
13. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #6 barb fitting (Solvent
Purge). (see diagram above)
14. Push the other end into the push fitting located at the top of solvent purge portion of the
RTM Flush Valve mounted on the gun. (see drawing below)
RTM Valve / Injection Port:
15. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #7 barb fitting (RTM Valve
“ON”). (see diagram above)
16. Push the other end into the push fitting located on the bottom of the air cylinder of the
RTM Valve, just below t he “OFF” signal. (see drawing below)
17. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #8 barb fitting (Vacuum
Valve “OFF”). (see diagram above)
18. Push the other end into the push fitting located at the top of the RTM Valve. (see
drawing below)
Gun Control:
19. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp onto the tube and then attach it to the #9 bar b fitting (Gun “ON”
signal). (see diagram above)
20. Attach the other end into the fitting located at the front of the Pro Gun. (see drawing
below)
21. Mark both ends of the poly tube appropriately and put one end thru the inner guard and
slide the hose clamp on to the tube and then attach it to the #10 barb fitting (Gun “OFF”
signal). (see diagram above)
22. Attach the other end into the fitting located at the back of the Pro Gun. (see drawing
below)